05:25:08.470		Running procedure: 8.4.3.2.3
05:25:08.471		This procedure is enabled because the following options:
05:25:08.471		- supports.analogOutput.commands == true
05:25:08.471		- supports.disable.analogOutput == true
05:25:08.471		step: 1
05:25:08.471		- The DUT's analog outputs can be uninstalled or disabled through its configuration
05:25:08.471		step: 2
05:25:08.471		- Uninstall or disable every analog output point on the DUT
05:25:08.471	[PLG]	All analog output status points were uninstalled
05:25:08.471	[PLG]	Cycling power
05:25:08.472		step: 3
05:25:08.472		- Direct Operate No Ack(0x06) fir: 1 fin: 1 con: 0 uns: 0 seq: 0x00
05:25:08.472		- g41v2, 2-Byte Count and Index, count: 1
05:25:08.472		- [0] - value: 10 status: 0 (SUCCESS)
05:25:08.473	--A->	Direct Operate No Ack(0x06) fir: 1 fin: 1 con: 0 uns: 0 seq: 0x00
05:25:08.473		g41v2, 2-Byte Count and Index, count: 1
05:25:08.473		[0] - value: 10 status: 0 (SUCCESS)
05:25:08.473	--T->	fir: 1 fin: 1 seq: 0
05:25:08.473	--L->	master: 1 pri: 1 fcb: 0 fcv: 0 func: UNCONFIRMED_USER_DATA(0x04) 0xC4 length: 18 dest: 1024 src: 1
05:25:08.473	--P->	05 64 12 C4 00 04 01 00 30 DD
05:25:08.473		C0 C0 06 29 02 28 01 00 00 00 0A 00 00 F6 8F
05:25:08.473		step: 4
05:25:08.473		- Verify that no link layer frames are received within 2000 ms
05:25:10.475		frame receive timeout
05:25:10.475		step: 5
05:25:10.475		- Check that no analog control point operated
05:25:11.476	[PLG]	Analog output did NOT operate
05:25:11.476		Passed procedure: 8.4.3.2.3
05:25:11.476		restore
05:25:11.476		- Reinstall or re-enable the points that were uninstalled or disabled, so later procedures can use them
05:25:11.476	[PLG]	All points were reinstalled
05:25:11.476	[PLG]	Cycling power